SYSIO Board Front-Panel DIP-Switch Settings

SYSIO Board Front-Panel DIP-Switch Settings

The SYSIO board front panel DIP switches are used to set up system operating characteristics such as the type of user interface. SIO Front-Panel DIP-Switch Functions describes the ON and OFF functions of each switch. For more information on the SYSIO board, refer to the Adept MV Controller User's Guide.

Table 6-10. SIO Front-Panel DIP-Switch Functions

Switch

OFF Function

ON Function

1

Do not autostart

Attempt autostart

2

None

None

3

1. V+ Monitor via graphics (if possible)1

V+ Monitor on terminal connected to CPU #1

4

V+ graphics via VGB

V+ graphics via AdeptWindows (also see switch 5)

5

AdeptWindows via Ethernet (if switch 4 is ON)

AdeptWindows via serial port (if switch 4 is ON)2

6

Use IP data in NVRAM

Use default IP data3

7

None

None

8

None

None

Notes:
1. If switch #3 is off, and graphics (via VGB or Ethernet AdeptWindows) are not available, the V+ Monitor reverts to the terminal connected to CPU #1 (main CPU).

2. Switch #5 is ignored if switch #4 is OFF.

3. Switch #6 is ignored if switch #4 is OFF, and if switches #4 and #5 are both ON.

Switch	OFF Function	ON Function
1	Do not autostart	Attempt autostart
2	None	None
3	1. V+ Monitor via graphics (if possible)1	V+ Monitor on terminal connected to CPU #1
4	V+ graphics via VGB	V+ graphics via AdeptWindows (also see switch 5)
5	AdeptWindows via Ethernet (if switch 4 is ON)	AdeptWindows via serial port (if switch 4 is ON)2
6	Use IP data in NVRAM	Use default IP data3
7	None	None
8	None	None
Notes: 1. If switch #3 is off, and graphics (via VGB or Ethernet AdeptWindows) are not available, the V+ Monitor reverts to the terminal connected to CPU #1 (main CPU). 2. Switch #5 is ignored if switch #4 is OFF. 3. Switch #6 is ignored if switch #4 is OFF, and if switches #4 and #5 are both ON.